Planning outdoor paver patio with Spa

[Dave F]

Hello, Thanks for your answers to questions I've had on other projects. I'm now planning to put in a paver patio, which will include a Hot tub (which I own already, was in use for 10 years, installed by me without permit, then removed and stored due to having kids). Besides the hot tub, the patio will include a "built in" LP grill and side burner and small amount of countertop, a fire pit, and a small deck/landing for getting from the slider on the house down to the patio. It will also be partially surrounded by a privacy fence. I'm not sure how much of this project falls under IRC code, but I know the installation of the hot tub does. The hot tub itself is self contained water wise, but will require a 220V power supply. When I had it in service it was connected using a 50 amp GFCI breaker at the panel, and 8/3 copper wire with a run of about 30 feet from the panel. I also had a disconnect on the wall next to the tub itself. The previous install was indoors, this will be outdoors. I will need to drill through a cinder block foundation to run the power out to the tub. I'm just curious what they will want in regards to the power supply circuit and the tub itself.

Thanks,

Dave Fenoff

[Jerry Peck - Codeman]