Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

The following Codemen are available to answer your questions:
All Codes and Standards - Jerry Peck, Codeman

Q&A Board links

  • FAQ



  • View New Questions

  • View Unanswered Questions

  • View Active Questions/Answers

  • Mark Questions as read

  • View Your Questions

  • Go To Your User Control Panel

  • Links to:
  • Construction Litigation Consultants

  • Florida Building Commission

  • Florida Building Codes Online

  • International Code Council

  • ICC Codes Free Online

  • Building Officials and Administrators of Florida

  • Product Approvals
  • Florida Product Approval

  • ICC Evaluation Reports Search

  • Miami-Dade NOA Search

  • Inspector and Contractor License Search
  • Search Florida Licenses

  • Technical links
  • Technical Information page

  • Contact Codeman

  • Custom Search

    Minimum floor slope in a terrace

    Minimum floor slope in a terrace

    New postby wagurto on Thu May 17, 2018 8:59 am

    Is there a minimum floor slope to drain rain water in Florida? I now the minimum roof slop is 1/4" : 12"
    but what about tiled roof terraces?
    Posts: 14
    Joined: Wed Jan 17, 2018 8:00 pm

    Re: Minimum floor slope in a terrace

    New postby Jerry Peck - Codeman on Thu May 17, 2018 4:42 pm

    "Minimum floor slope in a terrace"

    wagurto wrote:Is there a minimum floor slope to drain rain water in Florida?

    Depends on the system installed below it.

    The floor surface, to drain properly, should be a minimum of 1/8" per foot slope, with a maximum slope of 1/4" per foot (more than 1/4" per foot and the floor is sloped enough to make walking on it a potential issue).

    The critical aspect is: what is the system below the roof top terrace floor and what does it require?

    Other than standing water being an issue on a "flat" (true "flat" no slope floor) and its likelihood for mildew growth and being slippery when wet (and even more slippery when mildewed and wet), the tile should be able to take the water on it. And, no, I am not recommending a "flat" (no slope) floor as there will be standing water issues (slippery, mildew growth, etc), but concrete, tile, and the like can take basically being flat and water draining off/drying out on it ...

    ... it is what is under the tile/other floor surface that matters:
    - What is its intended design drainage system?
    - What is ts intended drainage slope within the system?
    - Does it have a minimum (and maximum) slope of the floor surface which gets installed on top of it?
    Jerry Peck - CodeMan
    Construction and Litigation Consultant - Retired
    User avatar
    Jerry Peck - Codeman
    Site Admin
    Posts: 1164
    Joined: Fri Dec 12, 2008 12:06 pm

    Return to Roof coverings: Shingles, tile, slate, built-up roofs, single ply, modified, TPO-EPDM-PVC, metal, etc.

    Who is online

    Users browsing this forum: No registered users and 2 guests