Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

|
AskCodeMan.com
|
The following Codemen are available to answer your questions:
All Codes and Standards - Jerry Peck, Codeman


Q&A Board links
  • REGISTER

  • FAQ

  • LOGIN

  • Q&A BOARD INDEX

  • View New Questions

  • View Unanswered Questions

  • View Active Questions/Answers

  • Mark Questions as read

  • View Your Questions

  • Go To Your User Control Panel




  • Links to:
  • Construction Litigation Consultants


  • Florida Building Commission

  • Florida Building Codes Online


  • International Code Council

  • ICC Codes Free Online


  • Building Officials and Administrators of Florida




  • Product Approvals
  • Florida Product Approval

  • ICC Evaluation Reports Search

  • Miami-Dade NOA Search




  • Inspector and Contractor License Search
  • Search Florida Licenses




  • Technical links
  • Technical Information page


























































  • Contact Codeman



  • Custom Search

    Does a screen constitute a guard

    Does a screen constitute a guard

    New postby mtCDCcb on Mon May 06, 2013 2:59 pm

    We are building a screened in porch. There are portions of the porch that are screened within 36" of the ground surface. Does the mesh screening meet the requirements for guards?
    mtCDCcb
     
    Posts: 79
    Joined: Thu May 26, 2011 11:59 am

    Re: Does a screen constitute a guard

    New postby Jerry Peck - Codeman on Mon May 06, 2013 6:28 pm

    No, you will need to install a proper guard either inside or outside the screen enclosure, typically, the choice is to install the guard in the screen enclosure between the chair rail and the bottom rail, however, without the forethought of doing that, many chair rails are installed too low to meet the required height of the guard, which means another chair rail needs to be installed above the existing one.

    The openings in the guard between the vertical balusters you would install must be small enough so as to not allow a 4" sphere to pass through, which means the vertical balusters should not be flimsy skinny tubes - if they are they will deflect out of the way and allow the 4" sphere to pass through.

    The guard in-fill (the vertical baluster part filling in the space between the top rail and bottom rail of the guard is the "in-fill") needs to resist a 50 pound horizontally applied load. Basically, try to push the 4" sphere through the opening with 50 pounds of force, the guard in-fill should not allow you to do that.
    Jerry Peck - CodeMan
    AskCodeMan.com

    Construction and Litigation Consultant
    Construction Litigation Consultants, LLC.
    ConstructionLitigationConsultants.com
    User avatar
    Jerry Peck - Codeman
    Site Admin
     
    Posts: 1107
    Joined: Fri Dec 12, 2008 12:06 pm


    Return to Stairways, Ramps, Handrails and Guards: Stairways, ramps, handrails, guardrails, landings, entry stoops/porches, recessed floor areas



    Who is online

    Users browsing this forum: No registered users and 4 guests



    www.AskCodeMan.com