AskCodeMan
When you have questions regarding construction and building codes, inspections, or you simply want to know how construction is supposed to be done ... you have come to the right place.
Custom Search
Diagonal Bracing Gable Roof Ends
First unread post • 3 posts • Page 1 of 1
Diagonal Bracing Gable Roof Ends
by Hank S on Wed Dec 15, 2010 10:26 pm
I inspected a stick-built 2x6 rafter framed gable roof today and was looking for any code reference regarding a requirement for diagonal bracing at the gable ends. Louvered vents are located at the ends. I live in North GA.
- Hank S
- Posts: 10
- Joined: Wed Dec 15, 2010 9:45 pm
Re: Diagonal Bracing Gable Roof Ends
by Jerry Peck - Codeman on Wed Dec 15, 2010 11:28 pm
Georgia uses the 2006 IRC with Georgia amendments, but there are no amendments relating to gable ends or gable end bracing.
Gable end bracing is not spelled out in the IRC, although I believe it should be as it is a critical factor under many loading conditions.
Gable end bracing is not spelled out in the IRC, although I believe it should be as it is a critical factor under many loading conditions.
Jerry Peck - CodeMan
AskCodeMan.com
Construction Litigation Consultant - Retired
Construction and Code Consultant - Semi Retired
AskCodeMan.com
Construction Litigation Consultant - Retired
Construction and Code Consultant - Semi Retired
-
Jerry Peck - Codeman - Site Admin
- Posts: 1199
- Joined: Fri Dec 12, 2008 12:06 pm
Re: Diagonal Bracing Gable Roof Ends
by Hank S on Wed Dec 15, 2010 11:52 pm
Thanks Jerry. Yes, I referenced the GA Amendments along with the Mandatory Codes for the state and could not come up with anything.
- Hank S
- Posts: 10
- Joined: Wed Dec 15, 2010 9:45 pm
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest