Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

|
AskCodeMan.com
|
The following Codemen are available to answer your questions:
All Codes and Standards - Jerry Peck, Codeman


Q&A Board links
  • REGISTER

  • FAQ

  • LOGIN

  • Q&A BOARD INDEX

  • View New Questions

  • View Unanswered Questions

  • View Active Questions/Answers

  • Mark Questions as read

  • View Your Questions

  • Go To Your User Control Panel




  • Links to:
  • Construction Litigation Consultants


  • Florida Building Commission

  • Florida Building Codes Online


  • International Code Council

  • ICC Codes Free Online


  • Building Officials and Administrators of Florida




  • Product Approvals
  • Florida Product Approval

  • ICC Evaluation Reports Search

  • Miami-Dade NOA Search




  • Inspector and Contractor License Search
  • Search Florida Licenses




  • Technical links
  • Technical Information page


























































  • Contact Codeman



  • Custom Search

    B-Vent Installation

    B-Vent Installation

    New postby aaronm on Thu May 02, 2013 1:32 pm

    Too often I observe B-Vents installed out of plumb above the roof line. I find nothing in the IRC regarding this. Is there a standard one can refer to?
    "What the plainspoken man lacks in subtlety he makes up in clarity." - A.D. Miller

    www.texasinspector.com
    aaronm
     
    Posts: 55
    Joined: Fri Jan 09, 2009 8:02 am

    Re: B-Vent Installation

    New postby Jerry Peck - Codeman on Thu May 02, 2013 7:52 pm

    Hi Aaron,

    Nothing specifically about that other than the various installation instructions and codes address 'vertical', 'horizontal slope 1/4" per foot' and 'offsets'.

    I doubt the B vent sections above the roof are so far from 'vertical' that the 'offset' would create a problem within the allowances allowed within the code and/or manufacturer's installation instructions.

    I'm not sure if the word "vertical" is used in the manufacturer's installation instructions, but the drawings I've seen show 'vertical' and 'offsets', thus pushing hard on the definition of "vertical" as meaning ... well ... "vertical" ... may be a losing battle.

    Another point you could address is that the code requires Type B Gas vent to be terminated in accordance with the manufacturer's installation instructions, which includes the flashing, storm collar, etc., and maybe some wording in there would help.

    Codes and manufacturer's installation instructions do not address, and cannot fix, "stupid".

    Consider addressing the not-vertical-vent-above-the-roof from this aspect: the vent needs to be secured and supported to withstand the wind loads, and being as you 'know' the contractor installed the B-vent "vertically" at the time of installation, the only explanation left is that 'the wind must have blown it crooked', therefore it is simply a matter of adding proper supports and straps as necessary to support and secure the B-vent "vertically" ... just like when the installer first installed it.
    Jerry Peck - CodeMan
    AskCodeMan.com

    Construction and Litigation Consultant
    Construction Litigation Consultants, LLC.
    ConstructionLitigationConsultants.com
    User avatar
    Jerry Peck - Codeman
    Site Admin
     
    Posts: 1104
    Joined: Fri Dec 12, 2008 12:06 pm


    Return to Fuel Gas: Gas appliances (except Fireplaces, see Fireplaces), gas furnaces, fuel oil appliances, combustion air



    Who is online

    Users browsing this forum: No registered users and 2 guests



    www.AskCodeMan.com
    cron