Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

|
AskCodeMan.com
|
The following Codemen are available to answer your questions:
All Codes and Standards - Jerry Peck, Codeman


Q&A Board links
  • REGISTER

  • FAQ

  • LOGIN

  • Q&A BOARD INDEX

  • View New Questions

  • View Unanswered Questions

  • View Active Questions/Answers

  • Mark Questions as read

  • View Your Questions

  • Go To Your User Control Panel




  • Links to:
  • Construction Litigation Consultants


  • Florida Building Commission

  • Florida Building Codes Online


  • International Code Council

  • ICC Codes Free Online


  • Building Officials and Administrators of Florida




  • Product Approvals
  • Florida Product Approval

  • ICC Evaluation Reports Search

  • Miami-Dade NOA Search




  • Inspector and Contractor License Search
  • Search Florida Licenses




  • Technical links
  • Technical Information page


























































  • Contact Codeman



  • Custom Search

    insulation integrity

    insulation integrity

    New postby Dennis on Sun Nov 07, 2010 7:49 am

    In a attic with blown insulation R-value at 30, the a/c ducts are stapped above the bottom truss right above the ceiling, is there a problem with the a/c ducts and insulation, with the code? Located in Florida.
    Dennis
     
    Posts: 1
    Joined: Sun Nov 07, 2010 7:33 am

    Re: insulation integrity

    New postby Jerry Peck - Codeman on Sun Nov 07, 2010 7:31 pm

    Hi Dennis,

    The ducts should be either under, or above, the insulation, not "in" the insulation.

    As you describe the ducts on the top of the bottom chords, the insulation will not meet the require minimum R-value, which is based on inches of thickness for the different insulation materials. The insulation certificate (usually stapled to a truss at the attic access and visible when you remove the attic access access cover) will state the minimum thickness for a given R-value for that insulation. That is the *minimum* thickness for that insulation.

    Also keep in mind that the attic access cover must also be insulated to the same R-value as specified for the rest of the attic, as well as any vertical wall areas (down to drop soffit, up to higher ceilings, etc.) - those vertical wall areas are required to also meet the R-value specified for the attic ceiling, not just wall insulation R-value.

    Your blown in insulation will also require insulation dams at the soffits to the soffit vents and around the attic access opening.
    Jerry Peck - CodeMan
    AskCodeMan.com

    Construction and Litigation Consultant
    Construction Litigation Consultants, LLC.
    ConstructionLitigationConsultants.com
    User avatar
    Jerry Peck - Codeman
    Site Admin
     
    Posts: 1058
    Joined: Fri Dec 12, 2008 12:06 pm


    Return to Insulation and structural ventilation (crawlspaces and attics)



    Who is online

    Users browsing this forum: Yahoo [Bot] and 1 guest



    www.AskCodeMan.com