Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

The following Codemen are available to answer your questions:
All Codes and Standards - Jerry Peck, Codeman

Q&A Board links

  • FAQ



  • View New Questions

  • View Unanswered Questions

  • View Active Questions/Answers

  • Mark Questions as read

  • View Your Questions

  • Go To Your User Control Panel

  • Links to:
  • Construction Litigation Consultants

  • Florida Building Commission

  • Florida Building Codes Online

  • International Code Council

  • ICC Codes Free Online

  • Building Officials and Administrators of Florida

  • Product Approvals
  • Florida Product Approval

  • ICC Evaluation Reports Search

  • Miami-Dade NOA Search

  • Inspector and Contractor License Search
  • Search Florida Licenses

  • Technical links
  • Technical Information page

  • Contact Codeman

  • Custom Search

    Fireplace as required heat source

    Fireplace as required heat source

    New postby Tom Rees on Fri Nov 22, 2019 10:12 am

    What are the requirements for a gas fireplace to fill the requirement that every habitable space (IRC 303.8 Required heating) have a heat source. This comes up often that an addition such as a family room is put on the house and they didn't extend the heat ducts to this room but did install a gas fireplace in the addition. I think I remember that the fireplace had to have a thermostat but I am not sure. Thank you.
    Tom Rees
    Posts: 6
    Joined: Fri Jun 26, 2009 9:36 am

    Re: Fireplace as required heat source

    New postby Jerry Peck - Codeman on Fri Nov 22, 2019 11:00 am

    While the code does not clearly state that a 'heater' without a thermostat is not permitted to be counted as 'the' required heat source, the wording of the code clearly indicates that is the intent:

    (bold and underlining are mine)
    - R303.10 Required heating.
    - - Where the winter design temperature in Table R301.2(1) is below 60°F (16°C), every dwelling unit shall be provided with heating facilities capable of maintaining a room temperature of not less than 68°F (20°C) at a point 3 feet (914 mm) above the floor and 2 feet (610 mm) from exterior walls in habitable rooms at the design temperature. The installation of one or more portable space heaters shall not be used to achieve compliance with this section.

    "capable of maintaining"

    How else can that be done without the use of a thermostat?

    I suppose someone could try to claim that if a fireplace produces enough heat to provide the required heat for the coldest day/night to be experienced, one could stretch that to mean 'turn the heat ALL THE WAY UP' and roast when it gets too hot ... just so it will be hot enough to meet the coldest cold?

    Not in my book, but people will stretch things to be cheap.

    If there is no thermostat, then the gas fireplace doesn't count. And, just because there is a thermostat for the gas fireplace does not mean it counts either as it may not have a high enough Btu/hr rating to heat the area.

    While we have a central heating system, we also have a gas fireplace in the great room (living room/family room with 14 foot peak at the ceiling), with a remote, and there is a thermostat in the remote - but even on high setting, the gas fireplace does not produce heat to get warm beyond about 4 feet into the room from the fireplace. We only use the fireplace for sitting in front of it for the effect of sitting in front of a fire - it is not needed for heating ability.
    Jerry Peck - CodeMan

    Construction and Litigation Consultant
    Construction Litigation Consultants
    User avatar
    Jerry Peck - Codeman
    Site Admin
    Posts: 1136
    Joined: Fri Dec 12, 2008 12:06 pm

    Return to Mechanical: Heating and cooling equipment, duct work, ventilation and exhaust fans

    Who is online

    Users browsing this forum: No registered users and 2 guests