Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

|
AskCodeMan.com
|
The following Codemen are available to answer your questions:
All Codes and Standards - Jerry Peck, Codeman


Q&A Board links
  • REGISTER

  • FAQ

  • LOGIN

  • Q&A BOARD INDEX

  • View New Questions

  • View Unanswered Questions

  • View Active Questions/Answers

  • Mark Questions as read

  • View Your Questions

  • Go To Your User Control Panel




  • Links to:
  • Construction Litigation Consultants


  • Florida Building Commission

  • Florida Building Codes Online


  • International Code Council

  • ICC Codes Free Online


  • Building Officials and Administrators of Florida




  • Product Approvals
  • Florida Product Approval

  • ICC Evaluation Reports Search

  • Miami-Dade NOA Search




  • Inspector and Contractor License Search
  • Search Florida Licenses




  • Technical links
  • Technical Information page


























































  • Contact Codeman



  • Custom Search

    AC on floor

    AC on floor

    New postby will5443 on Thu Jan 05, 2012 10:35 pm

    I came across new construction Tuesday (built in 2005 - went bankrupt, and now someone else owns it and they are starting to sell off units) where the heat pump unit in the closet was sitting on the floor. There are other issues (like insufficient return air) but my main question is - can this unit sit on the ground. I do have pictures, buy my mind is not working right and I cannot seem to upload them. Thanks for your help.
    Bill Siegel
    Florida Home Inspection Team Inc
    will5443
     
    Posts: 8
    Joined: Wed Dec 14, 2011 4:06 pm

    Re: AC on floor

    New postby Jerry Peck - Codeman on Thu Jan 05, 2012 11:21 pm

    Can the air handler/furnace/forced air unit set on the floor?

    That depends on several things, first would be a no if the return air opening is facing down, unless there is a return air duct in the floor.

    It also depends on if the manufacturer's installation instructions allow for 0 inches clearance under the unit, if your local code requires an auxiliary drain pan underneath the air handler or allows for alternatives, etc. If an auxiliary drain pan is required and the unit is bottom return air/supply air, then the pan would restrict the air flow and the unit would need to be on a stand within the auxiliary pan.

    One thing to consider for setting on the floor is the clearance to combustible material electric heating elements are installed for backup emergency heat to the heat pump - being as the elements are exposed to the air flow there is the possibility that pieces from a hot element may fall through the unit down to a combustible floor, this would be more of a consideration for units which have bottom return air/supply air openings than for units which have front (or side) return air openings as the front (or side) return air units have enclosed bottoms which are typically steel.

    I have seen units which physically could be set on the floor as they had front return air, however, they were on stands above water heaters so I did not check to see what, if any, bottom clearances to combustible material they required in the installation instructions.

    Find an air handler unit on the floor would certainly raise some flags in my mind, as it did in yours, and I would need to find the installation instructions for most of the answers, the physical installation configuration could answer some of my other questions.

    If you noted the manufacturer and the model number, I would recommend a search on the internet for the installation instructions. If the unit is not very old, the installation instructions may be available on the manufacturer's web site, and if not, finding contact information on their web site for technical questions may lead to being able to get older model installation instructions even though not available on the manufacturer's web site. Sometimes emails work, sometimes it takes phone calls.
    Jerry Peck - CodeMan
    AskCodeMan.com

    Construction and Litigation Consultant
    Construction Litigation Consultants, LLC.
    ConstructionLitigationConsultants.com
    User avatar
    Jerry Peck - Codeman
    Site Admin
     
    Posts: 1089
    Joined: Fri Dec 12, 2008 12:06 pm


    Return to Mechanical: Heating and cooling equipment, duct work, ventilation and exhaust fans



    Who is online

    Users browsing this forum: No registered users and 1 guest



    www.AskCodeMan.com