Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

|
AskCodeMan.com
|
The following Codemen are available to answer your questions:
All Codes and Standards - Jerry Peck, Codeman


Q&A Board links
  • REGISTER

  • FAQ

  • LOGIN

  • Q&A BOARD INDEX

  • View New Questions

  • View Unanswered Questions

  • View Active Questions/Answers

  • Mark Questions as read

  • View Your Questions

  • Go To Your User Control Panel




  • Links to:
  • Construction Litigation Consultants


  • Florida Building Commission

  • Florida Building Codes Online


  • International Code Council

  • ICC Codes Free Online


  • Building Officials and Administrators of Florida




  • Product Approvals
  • Florida Product Approval

  • ICC Evaluation Reports Search

  • Miami-Dade NOA Search




  • Inspector and Contractor License Search
  • Search Florida Licenses




  • Technical links
  • Technical Information page


























































  • Contact Codeman



  • Custom Search

    Valley flashing

    Valley flashing

    New postby RICHARD TAN on Sat Mar 28, 2009 10:16 pm

    Is valley flashing to be extended out 4" oc, how about the edge or end of flashing?
    RICHARD TAN
     
    Posts: 60
    Joined: Wed Jan 14, 2009 9:43 am

    Re: Valley flashing

    New postby Jerry Peck - Codeman on Sat Mar 28, 2009 11:51 pm

    Hi Richard,

    The valley flashing is required to be a minimum of 16 inches wide, centered over the valley, and carried all the way to, but not necessarily over, the drip edge.

    However, by carrying the sides of the 16 inch wide valley metal to the edge of the drip edge, an overhanging 'V' shape is created.

    This 'V' shape may be left, the 'V' may be cut back along the drip edges then across the center to create a smaller 'v', or it would be trimmed back to the inside corner following the drip edge line.

    Most often, though, what roofers do to leave a smaller 'v' is to stop the valley metal short, sometimes at the inside roof edge of the drip edge roof face, which means the valley metal is not installed properly and fully to the drip edge, and sometimes they even stop the valley metal back further to reduce the 'v' even more.

    One thing I always did was use my tape measure and measure across the wide straight edge of the bottom of the 'V', that should measure 16 inches minimum.

    If it measure less, look along the top of the drip edge and see if the valley metal was trimmed back even with the drip edge (you will rarely find this done, which is an acceptable method of reducing the size of the 'v') or if you see the end of the valley metal extend up under the roof covering short of the edge (which is what you will likely find 90% of the time and which is wrong).

    Codeman
    Jerry Peck - CodeMan
    AskCodeMan.com
    Construction and Litigation Consultant - Retired
    User avatar
    Jerry Peck - Codeman
    Site Admin
     
    Posts: 1166
    Joined: Fri Dec 12, 2008 12:06 pm


    Return to Roof coverings: Shingles, tile, slate, built-up roofs, single ply, modified, TPO-EPDM-PVC, metal, etc.



    Who is online

    Users browsing this forum: No registered users and 0 guests



    www.AskCodeMan.com
    cron