Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

|
AskCodeMan.com
|

Custom Search

HVAC Vent

HVAC Vent

New postby mbmorris on Fri Jan 08, 2010 10:11 pm

Is this vent in the WRONG place?100108 027.jpg

Side wall view...100108 033.jpg

This is the unit in the basement that it comes from...100108 034.jpg

Here is the exit point in the basement...
You do not have the required permissions to view the files attached to this post.
mbmorris
 
Posts: 3
Joined: Fri Jan 08, 2010 9:48 pm

Re: HVAC Vent

New postby Jerry Peck - Codeman on Fri Jan 08, 2010 11:47 pm

Hi Matt,

Is the vent in the wrong place?

Possibly, but probably not. It all depends on what the manufacturer's installation instructions state for their clearances from building openings and areas. Do you have the manufacturer and model number where I could get the installation instructions and find out what they state are the required minimum clearances?

Regardless of "location" of the vent, the vent is not routed correctly. First, I doubt it is allowed to go through the wall that way, for several reasons, including but not limited to: a) allowing/causing water to run down the outside of the vent to the interior; b) the opening around the vent needs to be sealed to keep water and air out; c) the PVC vent pipe is required to be properly supported.

The duct work is also not properly supported.

Also have another question: That reddish area along the bottom of the wall in the first photo, is that from rain splash or is that from snow depth from the past? What state and part of the country are you in? If that is snow depth, then the height of that vent may well be too low.
Jerry Peck - CodeMan
AskCodeMan.com
Construction Litigation Consultant - Retired
Construction and Code Consultant - Semi Retired
User avatar
Jerry Peck - Codeman
Site Admin
 
Posts: 1201
Joined: Fri Dec 12, 2008 12:06 pm

Re: HVAC Vent

New postby mbmorris on Sat Jan 09, 2010 12:44 am

I can go look for the manufacturer number and find out, there arent any instructions around it. The house is a foreclosure that was started about 3 years ago but never finished.

Its in Georgia, the spash is from our Georgia "red" clay!

It had some moisture inside and in the hole under the PVC pipe. There was also some condensation on the inside of the vent pipe and a icecicle about 12", but the temp was 27 outside today.

There is also a furnace in the attic with the vent pipe going out the roof. It has a great deal of moisture that was running out of the vent pipe and into the metal housing of the furnace unit. Should there be a straight pipe or an elbow on it above the roof line? Here is the photo I took.100108 031.jpg

Thank for your help.

Here is a front view of the whole house...its nice but needs some attention...100108 002.jpg
You do not have the required permissions to view the files attached to this post.
mbmorris
 
Posts: 3
Joined: Fri Jan 08, 2010 9:48 pm

Re: HVAC Vent

New postby Jerry Peck - Codeman on Sat Jan 09, 2010 10:25 am

Jerry Peck - CodeMan
AskCodeMan.com
Construction Litigation Consultant - Retired
Construction and Code Consultant - Semi Retired
User avatar
Jerry Peck - Codeman
Site Admin
 
Posts: 1201
Joined: Fri Dec 12, 2008 12:06 pm

Re: HVAC Vent

New postby mbmorris on Sat Jan 09, 2010 11:09 am

Yep Thats what it has in the attic, but the vent pipe is not sealed enough to keep all the condensation inside the vent pipe so its dripping into the unit...here 100108 086.jpg and here.
You do not have the required permissions to view the files attached to this post.
mbmorris
 
Posts: 3
Joined: Fri Jan 08, 2010 9:48 pm


Return to Fuel Gas: Gas appliances (except Fireplaces, see Fireplaces), gas furnaces, fuel oil appliances, combustion air



Who is online

Users browsing this forum: No registered users and 2 guests


cron